Results
2023-22-08: The FAA is superseding Airworthiness Directive (AD) 2023-04- 12, which applied to all Airbus SAS Model A350-941 and -1041 airplanes. AD 2023-04-12 required repetitive detailed inspections of affected cargo sealing tapes and applicable corrective actions. Since the FAA issued AD 2023-04-12, additional locations have been identified that are subject to the unsafe condition. This AD retains the requirements of AD 2023-04-12 and expands the inspection area, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
2008-06-05: The FAA is superseding an existing airworthiness directive (AD), which applies to all Airbus Model A330-200, A330-300, A340-200, and A340-300 series airplanes. That AD currently requires a revision of the airplane flight manual to include procedures for a pre-flight elevator check before each flight, repetitive inspections for cracks of the attachment lugs of the mode selector valve position transducers on the elevator servo controls, and corrective actions if necessary. This new AD retains the existing requirements, reduces the applicability of the existing AD, and adds terminating actions. For certain airplanes, this AD requires upgrading the flight control primary computers. This AD results from a report of cracks of the transducer body at its attachment lugs. We are issuing this AD to ensure proper functioning of the elevator surfaces, and to prevent cracking of the attachment lugs, which could result in partial loss of elevator function and consequent reduced controllability of the airplane.
2023-20-09: The FAA is adopting a new airworthiness directive (AD) for all MHI RJ Aviation ULC Model CL-600-2E25 (Regional Jet Series 1000) airplanes. This AD was prompted by a determination that a new airworthiness limitation is necessary. This AD requires revising the existing maintenance or inspection program, as applicable, to establish a new life limit for a certain main landing gear (MLG) retract actuator piston rod. The FAA is issuing this AD to address the unsafe condition on these products.
2008-05-03: We are adopting a new airworthiness directive (AD) for certain Boeing Model 747-100, -100B, -100B SUD, -200B, -200C, -200F, -300, 747SP, and 747SR series airplanes powered by General Electric (GE) CF6- 45/50 and Pratt & Whitney (P&W) JT9D-70, JT9D-3, or JT9D-7 series engines. This AD requires repetitive inspections to find cracks and broken fasteners of the rear engine mount bulkhead of the inboard and outboard nacelle struts, and repair if necessary. For certain airplanes, this AD mandates a terminating modification for certain inspections of the inboard and outboard nacelle struts. This AD results from reports of web and frame cracks and sheared attachment fasteners on the inboard and outboard nacelle struts. We are issuing this AD to detect and correct cracks and broken fasteners of the inboard and outboard nacelle struts, which could result in possible loss of the rear engine mount bulkhead load path and consequent separation of the engine from the airplane.
2023-10-07: The FAA is adopting a new airworthiness directive (AD) for certain Airbus SAS Model A319-151N, -153N and -171N airplanes; Model A320-251N, -252N, -253N, -271N, -272N, and -273N airplanes; and Model A321-251N, -252N, -253N, -271N, -272N, -251NX, -252NX, -253NX, -271NX, and -272NX airplanes. This AD was prompted by a safety review of the airplane fuel system, which identified that the electrical harness routing of the engine low pressure shut off valve (LPSOV) is not adequately protected against uncontained engine rotor failure (UERF). This AD requires modification of the LPSOV electrical harness routing on either the left-hand engine or the right-hand engine, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
2023-19-07: The FAA is superseding Airworthiness Directive (AD) 2021-10- 20, which applied to certain ATR-GIE Avions de Transport R[eacute]gional Model ATR42-500 and ATR72-212A airplanes. AD 2021-10-20 required revising the existing aircraft flight manual (AFM) and applicable corresponding operational procedures to update a systems limitation, limiting dispatch with certain equipment inoperative, performing an operational test of a certain contactor and an electrical test of a certain battery toggle switch, and performing corrective actions if necessary. This AD was prompted by new procedures for modifying the wiring and replacing the battery toggle switch that have been developed that would terminate the AD requirements. This AD continues to require certain actions in AD 2021-10-20, and requires modifying the battery toggle switch wiring and replacing the battery toggle switch, and revises the applicability to include additional airplanes, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. This AD also prohibits the installation of affected parts. The FAA is issuing this AD to address the unsafe condition on these products.
2008-05-13: The FAA is superseding an existing airworthiness directive (AD), which applies to certain Bombardier Model CL-600-2B19 (Regional Jet Series 100 & 440) airplanes. The existing AD currently requires inspecting contactors 1K4XD, 2K4XD, and K4XA to determine the type of terminal base plate, and applying sealant on the terminal base plates if necessary. This AD requires an inspection to determine if certain alternating current (AC) service and utility bus contactors have a terminal base plate made from non-G9 melamine material, and corrective actions if necessary; or re-identification of the mounting tray of the contactors; as applicable. This AD also limits the applicability of the existing AD. This AD results from incidents of short circuit failures of certain AC contactors located in the avionics bay. We are issuing this AD to prevent short circuit failures of certain AC contactors, which could result in arcing and consequent smoke or fire.
2023-19-03: The FAA is adopting a new airworthiness directive (AD) for all Airbus SAS Model A330-200 series airplanes; Model A330-200 Freighter series airplanes; Model A330-300 series airplanes; Model A330-800 series airplanes; Model A330-900 series airplanes; Model A340-200 series airplanes; and Model A340-300 series airplanes. This AD was prompted by a report of cracks found in the fuel control unit housing assembly of a Honeywell GTCP331-350 auxiliary power unit (APU), which caused fuel leakage in the APU compartment. This AD requires replacing any affected APU fuel control unit or affected APU, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. This AD also prohibits the installation of affected parts under certain conditions. The FAA is issuing this AD to address the unsafe condition on these products.
2008-05-02: The FAA is superseding an existing airworthiness directive (AD), which applies to all EMBRAER Model EMB-135BJ, -135ER, -135KE, - 135KL, -135LR, -145, -145ER, -145MR, -145LR, -145XR, -145MP, and -145EP airplanes. That AD currently requires reviewing the airplane maintenance records for recent reports of vibration from the tail section or rudder pedals. The existing AD also currently requires repetitively inspecting the skin, attachment fittings, and control rods of rudder II to detect cracking, loose parts, wear, or damage; and related investigative/corrective actions if necessary. This new AD requires the existing repetitive inspection to be done with new service information. This new AD also requires replacing the locking tab washers on the control rods of the rudder II and installing springs on the hinge assemblies of the rudder II, which would terminate the repetitive inspection requirements. This AD results from reports of rudder vibration due to wear. We are issuing thisAD to prevent failure of multiple hinge fittings, which could result in severe vibration, and to prevent failure of the rudder control rods, which could result in jamming of the rudder II; and possible structural failure and reduced controllability of the airplane.
2023-18-01: The FAA is superseding Airworthiness Directive (AD) 2021-26-11 for all Rolls-Royce Deutschland Ltd. & Co. KG (RRD) Model RB211-Trent 875-17, 877-17, 884-17, 884B-17, 892-17, 892B-17, and 895-17 engines. AD 2021-26-11 required replacing the affected fuel pump on at least one affected engine. Since the FAA issued AD 2021-26-11, the FAA has determined that replacing all affected fuel pumps on all installed engines is necessary to address the unsafe condition. This AD was prompted by reports of single-engine events caused by water contamination, which led to corrosion on the fuel pump that resulted in loss of engine thrust. This AD requires replacing the affected fuel pump on at least one engine before further flight and replacing all affected fuel pumps within a specified compliance time. This AD would also prohibit installing any affected engine onto any airplane or any affected fuel pump onto any engine, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference (IBR). The FAA is issuing this AD to address the unsafe condition on these products.